CHIRP

1. What is the behavior you are seeing? no errors, radio loads up well. but when I want to select a Bank to scan I can do it in VFO A, in VFO B it just hangs on one bank or shows NO BANK. VFO A lets you select a Bank and works properly.
2. What is the behavior you were expecting?
   to be able to scan a Bank from both vfo's independently
3. Can you reproduce the problem all the time? Yes after an upload to the radio from CHIRP - NOTE: I was able to resolve the issue by using the Yaesu ADMS software, downloading from the radio, then uploading BACK to the radio, it seemed to clear the problem.
4. What are the steps required to reproduce the problem? after entering some memories and creating some custom BANKS, put vfo B into Memory mode by pressing V/M, push BAND key, then F, then BAND. it should now let you move between the BANKS that were created.
5. Is this specific to a certain radio model (driver) or something that you can reproduce with another radio? I've only had the problem on the FT1DR

I don't have the config handy but it is saved, if you need me to send it please email me and tell me where. .

THANKS
LOVE YOUR SOFTWARE - it's changed HAM radio for me!!!

John