CHIRP

THis is a forked update from NEW MODEL #901 issue. I thought i would post this as a bug on my own.

I added area repeaters via Repeater book. These repeaters require a PL tone. After i wrote to the device i went into the device and looked at the R-Code. The R-Code said OFF. So i switched it to the correct PL tone. After that i went toe chirp to try to download from the device. That was the point that i gained the UNSUPPORTED MODEL ERROR. I came here and looked at the issue and reset my device VIA Jim Unroe's advice. After resetting i proceeded to open my saved settings and upload them back to the device and once again added the R-Code to the same channel as last time (in this case channel 1) then tried to download again. I again got the unsupported model error. i unplugged the device then went back to the R-Code and switch it to off after which i tried to download from the device again and POOF! NO ERROR.

SO maybe it is a conflict withe the R-Code is what i am thinking. I can include a copy of my file if needed.

Hope this is the actual issue.

I just did a Reset to test this out. After resetting the device I then went to R-Code in the menu and set a PL Tone (88.5). Then I went into chirp and tried to download from the device. ERROR. Then I went back to the device and removed the R-Code. Went back to chirp and try the download again, NO ERROR.

I have just now reset the device again and set an r-code of 67.0. NO ERROR.
Reset again, R-code 69.3. ERROR
No Reset, R-Code 71.9. ERROR
Turn R-Code to off. NO ERROR

So I am going to assume any number above 67.0 in R-Code is going to throw an error.

Build version: CHIRP daily-20130630