CHIRP

With actual Chirp you should be able to download from your radio, I guess.
If that's true please save the image and send it here, if not please send the debug log (see instruction here http://chirp.danplanet.com/projects/chirp/wiki/How_To_Report_Issues#Getting-your-debug-log )

tnx

I am running build CHIRP daily-20130610

I get the following message...

"An error has occurred
Failed to communicate with radio: Radio not responding"

Using the same cable and my Baofeng UV-5R, I can up and download and, yes, I do change the radio make and model before trying.

Also using the same port and cable my KG-UVD1P 144/220 will connect to the earlier mentioned Wouxun software.

I went around and around with Wouxun about not being able to use a computer to program the 144/220 radio. They couldn't help.
I finally found software that worked at the above mentioned Main Trading Company.
"(use only on units purchased after 2/1/13)"

There must have been a change in firmware or hardware around 2/1/13.

The Wouxun software works, but is very limited.

thanks

I would like to help, but there was no file attached to your email to download.
Is there a link I can download it from ?

Thanks
Randall

PS: I have no problem sending the radio to someone as long as I get it back. But will not be able to ship before July 08, 2013…

The file can be downloaded from issue page at Chirp site (direct link http://chirp.danplanet.com/attachments/599/kguvd1new.py )

I'm located in italy ... i think it's easier to proceed remotely ;)

The image seems to have the same structure of ones from previous radio version (pre 2/1/13 I mean).
Please Randal, download from your radio (using the kguvd1new.py as before) and check all memories values and frequency ranges in settings.
I expect everything to be correct, if so you can try to edit memories and then upload back to radio.

I wait for your feedback to incorporate support for this radio in daily version.

Everything looks OK, only difference being instead of a +/- shift, it shows it as a "split". I assume this is because the radio was programed with the above mention Wouxun software and this is the way the Wouxun software works.

I made a couple of edits, added new frequencies in both the 144 and 220 ranges and I was able to upload these to the radio without any problem.

Thank you for your time and effort on CHIRP and this issue.

Randall