Bug #5469
openTH-9000 220 - Radio did not accept block at 0100
0%
Description
When using CHIRP to upload frequency data to my TH-9000 220 radio, I receive the error "Radio did not accept block at 0100".
I am able to upload data using the TYT TH-9000 software.
My TH-9000 144 and 440 rigs work fine with CHIRP.
Debug log is attached.
I have done searches both on the CHIRP website and with Google to see if anyone else has reported this issue, but I could find none.
Files
Updated by Gary Hughes over 6 years ago
Tony Scandurra wrote:
When using CHIRP to upload frequency data to my TH-9000 220 radio, I receive the error "Radio did not accept block at 0100".
I am able to upload data using the TYT TH-9000 software.
My TH-9000 144 and 440 rigs work fine with CHIRP.
Debug log is attached.
I have done searches both on the CHIRP website and with Google to see if anyone else has reported this issue, but I could find none.
I have the same problem. I can read from radio, but not write to it.
Updated by Bernhard Hailer over 4 years ago
- Status changed from New to Feedback
- Model affected changed from TH-9000 220 to TYT TH-9000 (220 MHz)
This looks like a cable issue. Please refer to these Wiki articles:
CableGuide
CableGuide FTDI OEM Cables
[RTSystemsCablesAndMavericks]
If there's no solution to be found in any of them, please read: How To Report Issues and provide a fresh debug log. Thank you!
If you are using a generic cable with a Prolific chip, you will very likely need to downgrade your driver to version 3.2.0.0.
It can be found at http://www.miklor.com/COM/UV_Drivers.php
Updated by Bernhard Hailer almost 4 years ago
- Target version set to chirp-legacy
Based on the original description, there might be an issue with the reported ID from that radio. Leaving this bug report open.