Actions
Bug #5627
closedCHIRP and Baofeng UV-3+
Start date:
03/06/2018
Due date:
% Done:
0%
Estimated time:
Chirp Version:
daily
Model affected:
Baofeng UV-3+
Platform:
Windows
I read the instructions above:
Description
When programming the UV-3R+ with CHIRP the repeater offset frequency is off by a factor of 1000. In order to get a 600KHz offset I had to enter .006 in the offset column. For 5MHz offset I had to enter .5 in the offset column. If I entered the actual offset in the column it would be off by 1000 times the entered value. I discovered this when reading the radio after it was programmed using the front panel controls.
Updated by M T over 5 years ago
Should this be closed as a duplicate of 6417, since that issue has a description of the root cause?
Updated by M T over 5 years ago
Or maybe a duplicate of #4635 in light of https://chirp.danplanet.com/issues/4635#note-4 ?
Updated by Bernhard Hailer almost 5 years ago
- Subject changed from CHIRP and Baogeng UV-3+ to CHIRP and Baofeng UV-3+
- Status changed from New to Closed
- Priority changed from High to Normal
- Target version set to chirp-legacy
- Chirp Version changed from 0.4.0 to daily
- Model affected changed from UV-3+ to Baofeng UV-3+
Actions