CHIRP

If I enter a new frequency with all repeater settings using the radio including the offset set to .60 MHZ and download to CHIRP and then upload back to the radio, the offset shows correctly when you bring up that menu again in the radio. Shows as .6MHZ

If I enter a new frequency with all repeater settings within the CHIRP interface (on the computer) including the offset again set to .6 MHZ then upload to the radio, the shift shows incorrectly when you bring up that menu in the radio. Instead of being .60 it displays as 7.60

Furthermore, once you bring up the menu in the radio and it displays as 7.60 it will never contact the repeater again, as it's transmitting on an incorrect frequency, unless you repower the radio and don't go into that setting. Once you look at the setting and see the 7.6 offset, none of the repeater memories will work correctly until the radio is repowered.

In the attached CHIRP file, memory 31 was entered using the radio and memory 32 was entered using CHIRP. They look identical, yet they don't act identically when uploaded back to the radio. 31 displays correctly and 32 displays the offset as 7.60MHZ