Bug #4473
openPuxing PX-2R Names
0%
Description
CHIRP daily-20170126
On the PX-2R chirp will neither read nor write Names to the first 10 memory locations. If the Name for a location is blank in the radio, and a name is set in chirp, the name remains blank after programming. If a name is set using the radio Menu interface and then read into chirp, noting is read. From location 11 on, it works as expected.
Updated by Richard Perlman almost 8 years ago
I have finally been able to get the Puxing software to run and compare it to chirp. First, the regular PX-2R software would not work with my radio. I needed to find the PX-2R-Plus software. While my radio says it is a PX-2R, the box says it is a Plus, and that is, it seems, the case. Note my radio has PX-2R on the case and inside the radio it is marked as Model:PX-2R U/v (tx/rx UHF, rx VHF).
When I read from the radio using the Puxing software it did indeed read blanks from the first 10 memory locations locations. However, when I entered values for those names it was able to write them out. I was then able to read the name values into chirp. But, it can't write out changes.
I also found a serious bug in the Puxing. The tx and rx frequencies are reversed in the PC & Chirp interface. In the Puxing software, you just write the tx freq in the rx column, and vice-versa. In chirp you need to enter the tx freq in the frequency column and then enter a backwards offset (I.e. a +5mHz offset is entered as -5mHz).
And, finally, although the radio can be set to receive VHF (through the radio interface) neither chirp nor the Puxing software will allow these frequencies to be set.
YMMV
Updated by Bernhard Hailer over 4 years ago
- Subject changed from Puxinf PX-2R Names to Puxing PX-2R Names
- Target version set to chirp-legacy
- Model affected changed from PX-2R to Puxing PX-2R