New Model #320
closedKG-816 Wouxun
100%
Description
Hello,
will inform you KG-816/Wouxun is working to read and write memory by using Wouxun KG-UVD1P settings.
Only problem is that UVD1P uses only 128 Memorys and the KG-816 uses 199 Memoryś.
It should be a small thing to open 200 Memorys by the KG-UVD1P and rename it to KG-816 to work with the 816 complete.
Thanks and congratulations for the fine work
Best regards Stefan DO1ESZ
P.S.If Beta Test is needed for the device KG-816 please contact me: do1esz@gmx.de
Files
Updated by Filippi Marco about 12 years ago
- Status changed from New to In Progress
- Assignee changed from Stefan Zugowski to Filippi Marco
- Chirp Version changed from 0.2.3 to daily
Please save the memory image from your radio and upload it to this issue.
I'm going to make changes to KG-UVP1P driver in, say, next week and it can be the right time to add support for KG-816.
Tnx
Updated by Stefan Zugowski about 12 years ago
Hello,
Wouxun KG 816 UHF Memory read out 128 from 199 Memory with KG-UVD1P settings.
Thanks and best regards
Stefan DO1ESZ
Updated by Filippi Marco about 12 years ago
Stefan, is your radio locked to work only in the UHF range 400-470MHz?
Thanks for collaboration
Updated by Stefan Zugowski about 12 years ago
Hey,
the KG816 is a Monoband Handheld, you can buy it as a 70cm or 2m
Version.
I own both of them and the behavior by programming is the same, means its not locked.
Best regards
Stefan DO1ESZ
Updated by Filippi Marco about 12 years ago
Good, I need some more info before to start writing code.
Is the image you upload from the UHF one?
Is the freq range I extracted from the image correct?
Can you please send also an image taken from the VHF radio?
... ready to work for you ...
Updated by Stefan Zugowski about 12 years ago
Morning Filippi,
The uploaded Image is from KG816 the 70cm Version, the Range is correct.
Unfortunally i ve send the 2m Version back to dealer for repair, untill now ive no memory file from the 2m radio
(was only a few Relay Frequencies on it), but i remember to read out and write with the Wouxun Version on Chirp perfektly (there were less than 128 Memorys programmed), but ive not store the img to disk, only checking if its work.
Hope this would be helpful
DO1ESZ Stefan
Updated by Filippi Marco about 12 years ago
- Status changed from In Progress to Feedback
- % Done changed from 0 to 90
A first implementation has been sent to the developers list and will be in next days daily build.
Please stress test it on as much KG816 radio as possible and report results.
73 de IZ3GME Marco
Updated by Filippi Marco about 12 years ago
- Status changed from Feedback to Closed
- % Done changed from 90 to 100